Instruction Manual

Safety Notes
Before working with this unit, read the warning and application instruc-
tions carefully and completely before operating the device.
1. The device is designed for indoor use only.
2. Light – Due to the risk of flash burn of the eyes it is not recommended
to look directly into the light source. The lighting must be switched
off before installation and/or maintenance. The device must not be
used when a failure may cause a personal injury.
3. Heat - In case of insufficient heat dissipation or when running the
light in flash mode with a too high duty cycle, the surface tempera-
ture may exceed 60 °C. Keep off flammable materials at any time.
4. Electricity - The housing is electrically isolated from the ground of
the power supply. Exceeding the permissible input voltage U
in
or
U
LED(+)
can lead to the destruction of the device or to a significant
shortening of the lifetime of the LEDs in the device.
5. Usage – Please prevent mechanical stress to the light surface during
operation. This will lead to a inhomogenious light emission.
6. Cleaning - The light emission surface has to be cleaned with a stan-
dard glass cleaner and a soft cleaning cloth. Do not use other materi-
el for cleaning as it will damage the device.
Wide Bar Light Series
Operating Manual
Technical Data
Model Sizes in Series
The illumination is available in the following sizes
1)
WBL-0410 WBL-0420 WBL-0430
1) size definition: WBL-0420 refers to a light field of 45mm x 200mm
Possible LED Colors
LED Abbr.
1)
Peak Wavelength
2)
White -WT 5000K, CRI80
Red -RD near 625nm
Infrared -IR near 850nm
Green -GN near 525nm
Blue -BE near 465nm
Yellow -YE near 580nm
1) Color option will be added to the model name aer the size information. SBL-0120-IR
refers to a bar with 850nm infrared light
2) This is an approximated value. The exact value also depends on LED temperature
and LED current
MBJ Imaging GmbH
Jochim-Klindt-Strasse 7 [phone] - 31
22926 Ahrensburg, Germany [e-mail]
www.mbj-imaging.com
Example: Model WBL-0420
Mechanical Integration
The light is equipped with M4 threaded holes at each end. It can be
used to fix the lighting to the specified position. In addition M2.5
threaded holes are provided at the two long sides to mount the foil
and filter holder set.
To ensure a long operational live time of the light additional heat
transfer measures at the mounting postions are highly recommended.
Manual WBL BarLight Series: Revision 04 - 27 January 2021. INDD file Rev07.
More 2D and 3D drawings can be found online:
www.mbj-imaging.com