Owner's Manual

②

Pedal

Crutch

Thin nuts must be locked

Thin Nut

Step 2 Assemble the left and right pedals

Step 3 Assemble the adjustment seat core and the adjustment handle core

Accessories: pedals (L, R), crescent wrenches, open-end wrenches (17#-19#)

Accessories: handlebar, handlebar post, seat post, seat, seat slider, front&rear adjustment knob,

hexagon socked head screw M8*14mm(including spring washer, at washer) (3pcs), open spanner

(13#-16#), Allen wrench (6#)

Take the front&rear adjustment knob, seat, seat slider and open-end wrench(12#-16#), assemble

them and place them in an open place; take the handlebar, handlebar post and hexagon socked head

screw M8*14mm (including spring washer and flat washer), assemble them and place them in an

open place. (as the picture shows)

Take the pedals, thin nuts, crescent wrenches, and open-end wrenches, distinguish L/R according to

the label, and install them on the corresponding crutches and tighten it, and use the crescent wrench

to fasten the thin nut on the thread of the pedal. (as the picture shows)

Warning: Please make sure to install the Left Pedal COUNTER-CLOCKWISE and all way in.

Please make sure to install the Right Pedal CLOCKWISE and all way in.

If improper installation, the tread of Crutch will be stripped and there is a risk of the pedals falling.

If not tightened enough, there is also a risk of causing noise too.

⑨

⑤

② ⑩

⑦

②

③

④

⑥

⑤

⑪

⑥

tight