USER MANUAL It’s radio as you know it plus… Please read this user manual carefully before using the receiver
Important to know about digital radio coverage Please note that digital radio is currently only available in Australian metropolitan cities. It is not available in remote area yet. You can visit www.digitalradioplus.com.au to discover the coverage of the available digital radio broadcasting around Australia by typing your living area postcode. Please make sure that your area has digital radio signal available to use the DAB+ mode.
Location of controls 1 2 3 4 Speaker LCD Display ON/ OFF Key Display Key 10. DAB+/ FM Mode Key 11.Previous Key 12. Select Key 13.
5 6 7 8 Scan Key Preset Key Menu Key Volume Down Key 14. 3.5mm Earphone Socket 15. DC Power Socket 16. Aerial Input 9. Volume Up Key 1. Switching your radio on for the first time 1.1 Power the device 1.1.1 Main Adaptor (supplied with the package). Connect the mains adaptor to the DC power socket of the radio to the wall socket. 1.1.2 Battery (not supplied). Open the battery door and insert 4 "AA” size alkaline batteries. Remark: Insert batteries correctly.
1.3 Changing radio stations 1.3.1 If you are not already in DAB+ mode, Press the "DAB+/FM" button to go to DAB+ mode. Then you can press "DAB+/FM" button again to go to FM mode. 1.3.2 Press the "◄◄" or "►►" button, to scroll through the stations. By default, the stations are listed in numerical and then alphabetical order. 1.3.3 In DAB+ mode, when the station that you would like to listen to is displayed, press the "Select" button.
and hold the "Scan" button for 2 seconds to begin a wider, national and full scan. A national and full scan takes approximately 1 minute but can take up to 3 minutes depending on the area and signal strength. 1.5 Storing a preset station Your digital radio can store up to 10 DAB+ stations and 10 FM stations in its preset memories for instant access to your favorite stations. 1.5.1 Tune your radio to the station that you wish to preset (see changing stations, 1.3). 1.5.
Note: If no station has been stored under the preset, the display will change to "Preset Empty" and then revert to the previously selected station after a few seconds. 1.7 Station Display Symbols You may see the following symbols displayed alongside a station name. Normally you will see these symbols under DAB+ mode. ? Station is not available/not active. This could be used if you try to tune into a secondary service/station at a time when it is not transmitting.
2. Using the Menu Key The "MENU" button enables you to change some of the default settings of your Radio, so that it works just the way you want it to. Use "Select" to confirm your choose, use "◄◄"or "►►" to scroll through the menu list. 2.1 Under DAB+ mode, the Main menus are as below 2.1.1 Station List All the stations will list out under the Station List, you can choose the listing order you want under the "Station Order" menu. 2.1.
Note: If only an empty □ is displayed, you are not receiving any signal at all for that particular digital radio channel in your area. 2.1.4.4 Adjust the position of the aerial on the radio, to obtain the maximum signal strength and press "Select" to exit back. 2.1.5 DRC (Dynamic range control) The dynamic range for each radio program is set by the broadcaster for each radio station and may be different for the types of program broadcast, such as pop or classical music or a chat show.
Use “Previous” and “Next” to change your choose on and , just press Select button to confirm your choose on , then return the radio to its original factory settings. The display will change to “Restarting…” followed a few seconds later by “Welcome to Digital Radio” and will begin scanning for stations. If you decide not to reset your radio at this point, please press “Menu” to return to the previous play mode. 2.1.7 SW version Choose this menu to see the SW version. 2.
Product Q & A If you are experiencing problems with your DAB+ radio there are some quick and easy checks that you can do, which may help to solve the problem. Radio reception is poor -Please check that the aerial is extended for the maximum signal strength and improved reception. -Use the manual tune (see 2.2), to adjust your aerial for the best reception.
