Manualshelf

Data Sheet

ManualsBrandsMB V&V TECH ManualsMisc. AccessoriesMultifunctional Power Shield 6+6 T800 for Arduino
21222324252627282930
Additional tips and tricks
Control the PS directly with push buttons
[Fig. 25 – Control outputs with push buttons]
You can connect up to six push buttons to control the outputs manually (they will be turned on
until the buttons are pressed). In this case, the Arduino board is no longer needed. On the other
hand, having connected the Arduino board and set its digital pins to input mode, you can
monitor button clicks. When a button is pressed, the input will have 4...5V. R1 is for protection
against short-circuiting.
27