Owner's Manual

OPERATION
9
ZONES, DISPLAY, ALARM & SLEEP
ZONE 1 Operation
ZONE 1 is connected to the unit’s on-board FRONT speaker and preamp-level RCA outputs.
 Quickly press and release the ZONE 1 button to select between the zone being
active or disabled. The LCD screen will indicate the status of the zone above the
button.
 Rotate the VOLUME/SEL knob up or down to adjust the ZONE 1 volume when it is in
the active state.
 When ZONE 1 is in the disabled state, the VOLUME/SEL knob only controls the
active zone. Otherwise, the ZONE 1 volume remains where it was left when disabled.
To match the output of ZONE 2 after re-enabling, simply turn the volume all the way
down and back to the desired level for both zones which then display equally.
 To mute ZONE 1, press and hold the ZONE 1 button to toggle between ON or OFF.
The LCD screen indicates the muting status.
ZONE 2 Operation
ZONE 2 is connected to the unit’s on-board REAR speaker and preamp-level RCA outputs.
 Quickly press and release the ZONE 2 button to select between the zone being
active or disabled. The LCD screen will indicate the status of the zone above the
button.
 Rotate the VOLUME/SEL knob up or down to adjust the ZONE 1 volume when it is in
the active state.
 When ZONE 2 is in the disabled state, the VOLUME/SEL knob only controls the
active zone. Otherwise, the ZONE 2 volume remains where it was left when disabled.
To match the output of ZONE 1 after re-enabling, simply turn the volume all the way
down and back to the desired level for both zones which then display equally.
 To mute ZONE 2, press and hold the ZONE 2 button to toggle between ON or OFF.
The LCD screen indicates the muting status.
Show Clock or Source Information
Press DISP button to show either the clock or source information. Depending on the source,
text information about the song or movie playing may be available on the display (such as
RDS-enabled FM stations, USB music files or Bluetooth streamed music).
Alarm Operation
The alarm built into the unit functions as a wake-up alarm. It could also be used to
automatically turn the unit on at a specific time.
 On the front panel using the “ALARM” button, turn ALARM to “ON” and set the wake-
up alarm time (see next page Alarm Time Setting). When the wake-up alarm time is
set, the unit will generate a wake-up beeping sound at the preset time. The beep
sound stops when any key pressed.