Owner's Manual

OPERATION

Alarm Time Setting Procedure

When ALARM is set to “ON”, press and hold the “ALARM” button again to set the time.

If the ALARM setting is “OFF”, simply press and hold the “ALARM” button to go directly to

setting the alarm. This will not turn the alarm on, it will only set the time. If no alarm time has

begun setting within 5 seconds, the alarm time setting mode is automatically cancelled.

 After entering the alarm time setting mode, the HH (hours) flash. Rotate the

VOLUME/SEL knob to set the hour. Next, press VOLUME/SEL knob. The MM

(minutes) flash. Rotate the VOLUME/SEL knob to set the minutes. Press the

VOLUME/SEL or “ALARM” button to exit.

 If the ALARM was not already set to “ON”, press the “ALARM” button to enable the

alarm for the time you just set.

Sleep Operation

The sleep function built into the unit allows the user to set a specific time when the unit will

automatically turn off from 1-59 minutes later.

 On the front panel using the “SLEEP” button, turn SLEEP to “ON” then set the sleep

time (see below Sleep Time Setting). When the sleep time is set, the unit will power

off automatically at the preset time.

Sleep Time Setting Procedure

When SLEEP is set to “ON”, the next menu item is SLEEP SET.

If the SLEEP setting is “OFF”, simply press and hold the “SLEEP” button to go directly to

setting the sleep time. This will not turn the sleep setting on, it will only set the time. If no

sleep time has begun setting within 5 seconds, the sleep time setting mode is automatically

cancelled.

 After entering the sleep time setting mode, the sleep timer will flash. Rotate the

VOLUME/SEL knob to set it between 01-59 minutes. Press VOLUME/SEL or

“SLEEP” button to exit.

 If the SLEEP function was not already set to “ON”, press the “SLEEP” button to

enable the sleep timer for the preset countdown time.

Display Dimmer

The LCD display brightness is adjustable.

 Press the DIM button below the disc slot and it toggles between LOW-MID-HIGH-OFF.

Unit Reset

When errors occur in the display or functions (such as a DVD not playing and won’t eject), you

can reset the unit to its initial status.

 Using a paper clip or small pen tip, press the RESET button on the face of the unit to

reset the unit. This will erase all settings and memory functions and reset to factory

defaults.