Owner's manual

Mono Amplifiers
OA500.1 / OA750.1 / OA1000.1
8
FEATURES:
- 1 Set of RCA inputs
- LEVEL: Variable sensitivity from 0.2V to 6V
- BASS BOOST: Adjustable 45Hz bass boost from 0dB to 12dB
- SUBSONIC: Variable from 10Hz to 40Hz (OA500.1 & OA1000.1) and 15Hz to 55Hz (OA750.1)
- LOW PASS: Variable from 40Hz to 300Hz (OA500.1 & OA1000.1) and 40Hz to 150Hz (OA750.1)
- POWER LED: Indicates the powered up and turned on condition
- PROTECTION LED: Indicates a high voltage, low voltage, short circuit,
hard clip, over heating or DC fault condition.
- LINE OUTPUT: Full range RCA pass through.
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Control checklist:
Refer to the section “Settings for Best Performance”
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers
Minimum final loudspeaker impedance:
which have multiple positive and negative connections for ease of wiring. The 2 positives
-OA500.1 = 2-Ohms
are the same internally and the 2 negatives are the same internally.
-OA750.1 & OA1000.1 = 1-Ohm
POWER INPUT
GND REM BATT+12V
SPEAKER OUTPUT
- - + +
FUSE
MONO
SUBWOOFER
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY + 12 Volts
VIA FUSE
DESIGNATED
MONO OUTPUT
FROM HEAD UNIT
(OA1000.1 Pictured Below End Panel Layout Varies Per Model)
OUTPUT INPUT
L L
R R
POWER BASS BOOST SUBSONIC LOW PASS LEVEL
PROTECT
REMOTE
0dB 12dB 10Hz 40Hz 40Hz 300Hz 6V 0.2V
OUTPUT INPUT
L L
R R
POWER BASS BOOST SUBSONIC LOW PASS LEVEL
PROTECT
REMOTE
0dB 12dB 10Hz 40Hz 40Hz 300Hz 6V 0.2V