Manual

MX-1 Connecting High Level Speaker Wires (with factory amp)
BASS REMOTE
High Level Speaker Wire Connections
1. Cut ( )the factory amplifier speaker wires coming from the amp to the speakers in half.
2. Connect the speaker wires from the amp to the MX-1 as show in the diagram on this page.
3. Connect the other end of wires from the speakers to the aftermarket amplifier as shown in
the diagram on page ?
4. If you experience audible noise (distortion) in the speakers upon completion of the installation,
connect the MX-1 “Radio” ( )ground to the factory radio ground wire as shown above.
SPEAKER WIRE INPUT
+ - + - + - + - + -
R/F L/F R/R L/R SUB RADIO
MXR-1 REMOTE
CONTROL
cut
cut
cut
cut
cut
cut
cut
cut
cut
cut
Factory Radio
High Level Speaker Wire Outpus
SUB L/R R/R L/F R/F
GND
+ - + - + - + - + -
Factory Amplifier
VOLUME
MIN MAX
GREEN: PRE-CLIP
YELLOW: SOFT CLIP
RED: HARD CLIP
MXR-1
Connect this end of the speaker
wires to the amplifier
7