Manual

MX-1 Connecting Low Level RCA Cables To Amplifier
+ 12 volts W/5
amp fuse
Optional input
Ground
+
_
+
_
+
_
+
_
+
_
Speakers
Subwoofer
Low Level RCA Outputs
PRE-AMP OUTPUT
BALANCED
LINE OUTPUT
POWER
OUT
REM
+
BAT
IN
REM
-
BAT
FRONT REAR SUBWOOFER
Right / Left Right / Left Right / Left
FRONT REAR SUBWOOFER
Remote Input
Aftermarket Amplifier
Low Level RCA Connections
1. Use high quality RCA cables to connect the MX-1 to the
aftermarket amplifier per the diagram on this page.
2. Observe the Left (white) and Right (red) polarity as well
as Front and Rear on both MX-1 and the aftermarket
amplifier.
Power Connections
1.Connect the remote (REM OUT) output of the MX-1 to the
remote input on the aftermarket amplifier.
2. Connect the battery (BAT+) terminal to a constant +12
volt source with a 5 amp in-line fuse (not supplied).
Note: Do not install the fuse until the entire installation
is complete and you are ready to test.
3. Connect the remote (REM IN) terminal to the radio
output wire that provides a +12 volt output when the radio
is on and 0 volts when the radio is off. If the radio does
not have a +12 volt output, do not use this terminal.
4. Connect the battery (BAT -) to chassis ground.
6