User Manual

OPERATION
7
POWER AND BASIC ADJUSTMENTS
Turn the Unit ON or OFF
Press POWER button to turn the unit ON. When the unit is switched on, press and hold
POWER button for 2 seconds to switch the unit OFF. A “GOOD BYE” message is displayed to
confirm power down.
Sound Adjustments
Press and release POWER button, then repeat to choose sound settings in the following
order: BASS-TRE-BAL-FADER-EQ-LOUD
 Bass – Choose from -7 to +7
 Treble – Choose from -7 to +7
 Balance – Choose Left or Right (up to 7 steps in either direction)
 Fader – Choose Front or Rear (up to 7 steps in either direction)
 EQ – If “OFF”, pressing the VOL + or VOL - buttons allow you to choose from pre-
programmed tone settings* :
o Classical
o Rock
o Pop
o Flat
o Jazz
o EQ OFF
o *Note: If one of the EQ sound settings is chosen, manual Bass and Treble adjustments are
disabled. Only “BAL” and the name of the EQ setting will show in the Sound Adjustment
menu. To disable the EQ and allow manual Bass/Treble setting, simply scroll through the
settings until “EQ OFF” is displayed.
 LOUD – Press the VOL + or VOL – buttons cycle between ON or OFF**.
o **Note: Loudness gives a boost of low and high frequencies at low volumes, but can add
more distortion at high volumes. We recommend leaving in the OFF position and using an
EQ setting to achieve the sound profile that achieves the best low and high volume
performance for your system.
 Once the sound settings are chosen, the menu will automatically cancel after 5 seconds of
inactivity.
Setting Adjustments (USB, iPhone/iPod, Bluetooth or AUX Sources)
Press and release POWER button, then repeat after cycling the sound adjustments for the
setting menus: BEEP ON/OFF-CLOCK 12/24 - P_VOL
 In each menu item, pressing the VOL + or VOL - buttons allow you to select the sub-
settings.
 Once the settings are chosen, the menu will automatically cancel after 5 seconds of
inactivity.