Owner's Manual
Table Of Contents
25
FINAL AMP MOUNTING
FINAL AMPLIFIER MOUNTING (2018.5 Turbo S & 2019+ Models Continued)
STEP 2 – FINAL FITTING THE DUAL AMP PLATE
Carefully place the amplier plate into position as shown in Figure 20-4. Be sure the wiring harness and
connectors are all intact and nothing has come unplugged.
• if you have the Dynamix
®
ECU and/or OEM amplier bracket - Tighten the remaining two (2) 10mm
bolts to securely mount the dual amp plate. This is shown in Figure 20-4.
• If NO Dynamix
®
ECU or OEM amplier bracket - Secure the dual amplier plate. Simply substitute the
(2) 10mm screws in Figure 20-4 and use the two (2) T40 screws provided with the MB Quart Stage 5 kit
to securely mount the dual amp plate
STEP 3 – SECURE WIRING HARNESS
Secure the wiring harness with zip-ties to complete the installation. Ensure the routing of the harness avoids
contact with any sources of heat or moving parts.
Should the Dynamix ECU or OEM amplier (if present) ever need servicing, be sure to leave enough slack
in the harness so that the dual amp plate can be removed and either set aside or ipped over as it was
during initial tting on page 14.
Figure 20-4
10mm
10mm
Optional Mono
Subwoofer
Amplier Shown