Owner's Manual

21
INSTALL SOURCE UNIT
INSTALLING THE SOURCE UNIT (Non-Ride Command-Equipped)
Reassemble part of the front dash around the dash pocket area. Utilize the reverse method of how you
removed the center section of the dash pocket. This will allow source unit installation for the non-Ride
Command-equipped RZR vehicles. The harness can then be nished and connected in the proper location.
Final tting and reassembly of all panels is the last step of the installation after testing the system.
STEP 1 – RUN CONNECTIONS TO SOURCE UNIT AREA
Run the (2) RCA audio cables from the amplier location into the area where the source unit will be installed.
Be sure to observe left and right channels at the amplier. Make note of which connects to the two-channel
amplier and which connects to the mono amplier.
STEP 2 – MAKE SOURCE UNIT CONNECTIONS
With the harness routed through the vehicle and
everything connected to the amplier(s), make the
nal source unit electrical and RCA audio cable
connections in the dash as shown in Figure 17-1.
First, connect the short Delphi connector
with bullet connectors to the four-pin main
power harness, matching color for color with
the bullet connectors. Raise the completed
source unit mount to the dash area. Connect
the electrical (Delphi-style) connector as
shown in Figure 17-2. Connect the front RCA
preamp level outputs to the two-channel
amplier. Connect the sub RCA preamp level
outputs to the mono amplier (if present).
NOTE – As you raise the completed source unit to the dash area, ensure you
retained and installed the metal clip on the new source unit panel that was on
the back of the original dash pocket.
STEP 3 – SECURE THE SOURCE UNIT
Push the dash assembly into place until as shown in
gure Figure 17-3 until you feel and hear a snap as the
entire assembly seats into place. Re-attach the metal
clip with the T40 screw as shown in Figure 17-4.
Powering up the system and initial testing will be in a
subsequent step.
Figure 17-1
To Two-Channel Amp
To Optional
Mono Amp
Figure 17-2
Figure 17-4
T40 Torx Screw
Install
Metal Clip
Figure 17-3
Four-Pin Main
Power Harness