Owner's Manual

14
©2020 Maxxsonics USA, Inc.
AMPLIFIER PREPARATION AND MOUNTING (2018.5 Turbo S & 2019+ Models Continued)
STEP 2 – AMPLIFIER MOUNTING
Mount the MB Quart amplier(s) on the dual amplier
plate in the conguration shown in Figure 10.7. This
conguration is critical to make sure you can access
your ne-tune adjustments for level, low pass lter (LPF)
and bass boost.
STEP 3 – TRIAL FITTING THE DUAL AMP PLATE
With the amplier(s) mounted to the plate, place it into position as shown in Figure 10-8. Be sure there is
free movement of the wiring harness with enough length to connect to the amplier’s onboard connectors.
• if you have the Dynamix
®
ECU and/or OEM
amplier bracket - Loosely t the remaining two (2)
10mm bolts to check the t of the dual amp plate.
This is shown in Figure 10-8.
• If NO Dynamix
®
ECU or OEM amplier bracket
- Use the two (2) T40 screws provided with the MB
Quart Stage 5 kit to check the t of the dual amp
plate.
Connect the power and speaker wiring to the harness as
labeled. Do not zip-tie anything at this point as the dual
amp plate will not have its nal reassembly until after the system has completed the steps in the INITIAL
TESTING and FINE TUNING sections.
STEP 4 – REMOVE DUAL AMP PLATE FROM ITS LOCATION AND FLIP OVER
With the ampliers connected to the wiring harness, place a towel or blanket over the open hood area.
• If you have the Dynamix
®
ECU and/or OEM amplier bracket - Remove the rst two (2) 10mm bolts.
Remove the dual amp plate and ip it over on a towel or blanket to avoid scratching the amplier(s)
heatsink as shown in Figure 10-9. Next, remove the remaining two (2) 10mm bolts from the ECU or
OEM amplier mount (if present) and place the ECU to the side as when initially disassembled on page
8.
• If NO Dynamix
®
ECU or OEM amplier bracket - Remove the (2) T40 metal screws for the amp plate.
Remove the dual amp plate and ip it over on a towel or blanket to avoid scratching the amplier(s)
heatsink as shown in Figure 10-9.
This step will allow you to continue working on the other
parts of the installation and access other wiring until
you’re ready to power up the system, complete nal
testing and nalize the reassembly.
AMPLIFIER MOUNTING
Figure 10-7
Figure 10-8
10mm
10mm
Figure 10-9
Optional Mono
Subwoofer
Amplier Shown