Owner's Manual

AMPLIFIER MOUNTING

AMPLIFIER PREPARATION AND MOUNTING (2013-2018 Models)

Before installing the dual amplier plate with the amplier(s) in position, you must prepare the mounting area

in the vehicle to accept the plate.

NOTE - These instructions assume two ampliers and all speakers are present in a Stage 5 System. This

makes upgrading by adding a subwoofer and rear speakers easier. It’ll be prewired for those upgrades.

STEP 1 – LOOSEN STEERING COLUMN NUTS

Loosen the 16mm nuts that secure the steering column to the support frame shown in Figure 10-1a. These

nuts are very hard to loosen. Be careful. Do not remove these steering column nuts, only loosen to create

an 1/8 inch gap between the nut and the frame shown in Figure 10-1b. You will not re-tighten these nuts until

the installation of the whole system is nalized, tested and the vehicle is ready for reassembly.

STEP 2 – AMPLIFIER MOUNTING

Mount your amplier(s) on the dual amplier plate as shown in Figure 10-2 (below). This conguration is

critical to make sure you can access your ne-tune adjustments for crossover and bass boost.

STEP 3 – MOUNTING PLATE INSTALLATION

With the amplier(s) mounted to the plate, slide it into position with the double groove portion of the bracket

sliding between the steering column support shown in 10.1b (above) and the 16mm nuts and washers. Do

not tighten down yet. On the front edge, you will secure the plate with the 10mm bolt you removed from the

dash pocket which will also hold the bracket then will ultimately support the new dash pocket with the source

unit. The nished plate should look like Figure 10-3.

You will tighten the 16mm nuts and washers next to the steering column once reassembly of the vehicle

begins. This allows easy removal of the amplier plate for troubleshooting (if necessary).

NOTE - The dual amplier harness is designed to perfectly connect power and speaker connections on the

driver’s side of the ampliers while the RCA audio connections are on the passenger side of the RZR. Zip-tie

and secure the unused power and speaker harness for the subwoofer amplier if not used.

Figure 10-1a Figure 10-1b

1/8” Gap

Figure 10-2 Figure 10-3

10mm

Optional Mono

Subwoofer

Amplier Shown