Operation Manual

FEATURES:
• PROTECTION and POWER LED indicators
• The REMOTE jack enables a dash mount control for the BASS BOOST
• LOW PASS: Variable from 35Hz to 250Hz
• SUBSONIC FILTER: Variable from 15Hz to 35Hz
• BASS BOOST: 45Hz bass boost from 0dB to 9dB
• INPUT LEVEL sensitivities are variable from 0.2volts to 6volts
• Each model is capable of 1ohm minimum
MONO LINE INPUT
VIA Y-ADAPTER
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
MONO SUBWOOFER
ENG
2. Line Level, Bass EQ, Low Pass & Subsonic:
Refer the section “Setting up systems after installation for best performance.”
3. Bass Remote Module:
Plug in the optional Remote Bass Module to the REMOTE jack and control the
Bass Boost setting.
IMPORTANT: Minimum final loudspeaker impedance must be not lower than 1ohm.
1. Interconnect cable checklist:
Connect mono line input via Y-adapter from mono source or single
Left or Right RCA from stereo source.
IMPORTANT: Do not connect the Left and Right stereo signals
together to achieve a mono signal as this will damage the output
stage of source and possibly the input stage of the amplifier.
- Use at least 16 gauge speaker wiring. These amplifiers feature dual speaker
terminals, simplifying the hookup of multiple speakers.
BASIC OPERATION
M O N O - A M P L I F I E R S
DSC500.1/DSC1000.1
PARALLEL MONO
SUBWOOFERS
2 OHMS EACH MINIMUM