Operator`s manual

ZAGAT example description
Entering a POI via the Map
i
If the crosshairs are visible on the map,
you can enter POIs in the vicinity of the
crosshairs. If the crosshairs are not visible,
you can enter POIs in the vicinity of the
current vehicle location.
X
In the map display with the menu system
displayed (Y page 54) select Guide.
POIs are available:
Depending on the map scale selected, POI
symbols are displayed on the map. The
scale starting at which symbols are
displayed on the map varies from symbol
to symbol.
You can select which symbols COMAND
should display (Y page 57). The POI nearest
to the center of the screen is selected
automatically.
No POIs available:
A corresponding message is displayed.
i
This message is also displayed if the menu
item No Symbols under Map Display has
been selected (Y page 57).
X
To confirm message: Press n.
1
Information about the highlighted POI
2
Highlighted POI
X
To select a POI: Select Next or
Previous.
X
To start route calculation: Select Start,
see also (Y page 70).
You will be asked whether the POI should
be adopted as the destination.
X
Select Yes or No.
Route calculation starts if Yes is selected;
a new POI can be chosen if No is selected.
Route Guidance
General Notes
G
Warning
COMAND calculates the route to the
destination without taking account of the
following, for example:
R
Traffic lights
R
Stop and right-of-way signs
R
Lane merging
R
Parking or stopping prohibited areas
R
Other road and traffic rules and regulations
R
Narrow bridges
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/ traffic
situation. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
80
Route Guidance
Navigation