Operator`s manual

X
Remove the DVD from the slot.
X
Have the system software updated by an
authorized Mercedes-Benz Center.
i
It will only be possible to update the map
software once the system software has
been updated.
Map Software matches the Navigation
System and the current System Software
COMAND checks whether the DVD's map
data has already been installed.
Map Data Is already installed
The version release and a corresponding
message will be given on the display.
X
To confirm message: Press n.
COMAND ejects the DVD.
Map Data is not yet installed
The version release and a query as to whether
the update should be carried out will be given
on the display.
X
Select Yes or No.
If No is selected, COMAND ejects the DVD
automatically and the map data is not
updated.
X
Remove the DVD from the slot.
If Yes is selected, the map data is updated.
Updating the Map Data
While the update is in progress, a
corresponding message and a progress bar
are displayed. The progress bar fills from left
to right over the course of the update. The
navigation system is not functional until the
update is complete.
You cannot eject the DVD during the update.
If you switch COMAND off during the update,
this will interrupt the update and the update
will resume at the point of interruption when
the system is restarted.
While updating, COMAND may prompt you to
change the DVD. A corresponding message
is then displayed.
X
Press the Load button V.
The magazine menu appears. The magazine
compartment containing the current disc is
highlighted.
X
Press 9.
COMAND ejects the DVD.
X
Remove the DVD from the slot.
X
Insert the DVD requested by COMAND.
If the update has been completed
successfully, a corresponding message is
displayed.
X
To confirm message: Press n.
COMAND ejects the DVD.
X
Remove the DVD from the slot.
The update is complete.
If the update has not been completed
successfully, a message is displayed
indicating that the map update is not
possible.
X
To confirm message: Press n.
COMAND ejects the DVD.
X
Remove the DVD from the slot.
An unsucessful update may be caused by one
of the following:
R
DVD dirty or scratched.
X
Clean the DVD.
Please refer to the “Notes on DVD
discs” section (Y page 48).
X
Restart the update.
R
Overheating as a result of excessively high
temperatures in the passenger
compartment.
X
Wait until the passenger compartment
has cooled down.
X
Restart the update.
Input Restriction
There is an input restriction for vehicles in
certain countries.
The restriction is active for vehicle speeds
above approx. 3 mph. The restriction is
50
Introduction
Navigation