Operator`s manual

Entering Characters
Using the Speller
X
To select characters: Rotate ymz or
slide omp.
X
Slide qmr to switch between the lines in
the speller.
X
To confirm character selection: Press
n.
A possible option:
X
To switch predictive speller language
(character set): Select !.
With Number Keypad
Alternatively, you can enter characters using
the number keypad (direct input).
Example:
X
Press one of the number keys, e.g. 2, once
or repeatedly in succession.
After you have pressed it the first time, the
character display appears at the lower
edge of the display. The first available letter
is highlighted.
You see which characters you can enter with
that key. Each time you press the key, the
next character is highlighted.
For example, key 2:
R
Press once = A
R
Press twice = B
R
Press three times = C
Wait until the character display disappears.
Deleting an Entry
X
To delete individual characters: Select
õ at the bottom right of the speller and
press n.
or
X
Press the 2 button next to the
COMAND controller.
X
To delete an entire entry: Select õ
and press and hold n until the entire entry
is deleted.
or
X
Hold the 2 button down until the entire
entry is deleted.
Canceling an Entry
X
Select á at the bottom left in the speller
and press n.
or
X
Press the k button.
The address input menu appears.
Accepting the First List Entry
X
Press and hold n until the Enter
Destination menu appears.
Here you will find the accepted list entry.
or
If COMAND can match the characters
entered definitively to one town, the Enter
Destination menu appears automatically
with the selected list entry.
Switching to the List Without Predictive
Speller
If other entries for a town exist, or the name
exists more than once in the system, then
d is highlighted in the speller.
X
Press n.
It is also possible to change to the list at any
time during character input.
32
Operating COMAND
At a Glance