Operator`s manual

R
Keypad on the COMAND control unit
R
Multifunction steering wheel
R
Voice Control
The explanations in this section assume that
the mobile phone is connected to COMAND
via the Bluetooth
®
interface. Exceptions are
explicitly described.
Functional Restrictions
Under the following circumstances, the
phone may not yet be useable:
R
If it is not yet logged into a network. The
phone will try independently to log into a
network. If no network is available, you will
not be able to make “911” emergency calls.
If you try to make an outgoing call, the
message No Service appears briefly.
Activating the Mobile Phone
Mobile Phone With Bluetooth
®
Interface
Prerequisites for the Mobile Phone
For making calls using COMAND via the
Bluetooth
®
interface, you will need a
Bluetooth-enabled mobile phone.
i
Not all mobile phones available on the
market are comparably suitable. Further
information on suitable mobile phones and
connecting Bluetooth-enabled mobile
phones to COMAND is available via the
Internet at www.mbusa-mobile.com. Or
call the Mercedes-Benz Customer
Assistance Center at 1-800-FOR-
MERCedes (1-800-367-6372) (US), or
Customer Relations at 1-800-387-0100
(Canada).
Activating Bluetooth
®
Before you begin activation of your mobile
phone connection via the Bluetooth
®
interface please ensure it is compatible with
Bluetooth
®
handsfree profile 1.0 or higher
(Y mobile phone operating guide):
X
Switch on the mobile phone and enter the
PIN, if applicable (Y mobile phone
operating guide).
X
Activate Bluetooth
®
connection on the
mobile phone (Y mobile phone operating
guide).
i
On certain mobile phones, not only do you
have to activate the Bluetooth
®
function
but the device must also be made “visible”
for other devices.
Each Bluetooth
®
device has a Bluetooth
®
device name. It is recommended to give the
device a personal name, by which you can
clearly recognize your mobile phone.
i
If the Bluetooth
®
function on the
COMAND is switched off, the message
Bluetooth not activated in system
settings. appears.
X
Activate Bluetooth
®
connection on
COMAND (Y page 45).
Registering a Mobile Phone
(Authorizing)
When you use your mobile phone in
conjunction with COMAND for the first time,
you must register (authorize) it.
It is possible to register several mobile
phones. The connection is always established
to the mobile phone that was activated last.
When you authorize a new mobile phone, it is
activated automatically. You can switch
between the authorized mobile phones
(Y page 101).
Searching for a Mobile Phone
X
In the phone submenu select Phone
£Bluetooth Phones£Update.
COMAND searches for suitable
Bluetooth
®
phones within range and enters
them in the phone list.
Activating the Mobile Phone
99
Telephone
Z