User manual
User Manual of INVR-0xA / INVR-0xPOE series NVR
33
3.2 Operations in Live View Mode
In live view mode, there are many functions provided. The functions are listed below.
•
Single Screen: showing only one screen on the monitor.
•
Multi-screen: showing multiple screens on the monitor simultaneously.
•
Auto-switch: the screen is auto switched to the next one. And you must set the dwell time for each screen on
the configuration menu before enabling the auto-switch.
Menu>Configuration>Live View>General.
•
Start Recording: continuous record and motion detection record are supported.
•
Output Mode: select the output mode to Standard, Bright, Gentle or Vivid.
•
Playback: playback the recorded videos for current day.
•
Add IP Camera: The shortcut to add IP camera automatically or manually.
3.2.1 Using the Mouse in Live View
Table 3. 2 Mouse Operation in Live View
Icon Description
Enter the menu of the system by clicking the icon.
Switch to the single full screen.
Adjust the screen layout by clicking the specific icon.
Switch to the previous/next screen.
/
Enable/disable the auto-switch of the screens.
Start continuous recording or motion detection recording of all channels.
Add IP camera automatically or manually.
Enter the playback interface and start playing back the video of the selected
channel immediately.
Four modes of output supported, including Standard, Bright, Gentle and Vivid.
The dwell time of the live view configuration must be set before using Start Auto-switch.
If the corresponding camera supports intelligent function, the Reboot Intelligence option is included when
right-clicking mouse on this camera.
Figure 3. 1 Right-click Menu Bar