Manualshelf

User manual

ManualsBrandsMazi ManualsComputer equipmentINVR-0xPOE
101102103104105106107108109110
User Manual of INVR-0xA / INVR-0xPOE series NVR
103
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
INVR-0xA
INVR-0xPOE
Figure 9. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: NIC Type, IPv4 Address, IPv4
Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.
The valid value range of MTU is 500 ~ 9676.
For the PoE NVR, you need to configure the internal NIC address, so that IP addresses are assigned to
the cameras connected to the PoE or built-in switch interfaces.
4. After having configured the general settings, click Apply to save the settings.