Specifications

CONTROL SYSTEM [LF]
01-40–4
Fuel Cut
• Includes fuel cut under the following conditions except fuel cut at excessive engine speed according to engine
operation and deceleration fuel cut.
Sensor damage fuel cut
Purpose
• To prevent engine damage from abnormal ignition due to a malfunction input of a cylinder identification or the
engine speed signal.
Control condition
• When damage to the crankshaft position sensor or camshaft position sensor is detected.
D-range correction
(AT)
Purpose: Ensures engine speed stability during D-range shifting
Correction condition
• Throttle valve fully-closed and shifted into D range
Correction amount
• Low engine coolant temperature→large correction
B
High load volume
increase correction
Purpose: Improved engine output, decrease of exhaust gas
temperature
Correction condition
• According to engine speed when the throttle valve opening
angle is the fixed value or more, otherwise, according to engine
speed and charging efficiency
Correction amount
• High engine speed, high charging efficiency→large correction
B
Warm-up volume
increase correction
Purpose: When engine coolant temperature is low, maintains
combustion stability
Correction condition
• While at set engine coolant temperature
Correction amount
• High charging efficiency, low engine coolant temperature→large
correction
BB
A/C load increase
correction
Purpose: Maintains engine speed stability during A/C operation
Correction condition
• A/C is operating
Correction amount
• Low engine coolant temperature→large correction
BB
Acceleration increase
correction
Purpose: Corrects fuel injection delay during acceleration to ensure
drive stability
Correction condition
• When acceleration amount (change in the amount of charging
efficiency) is at set value or more
Correction amount
• Low engine coolant temperature→large correction
• Large acceleration amount→large correction
BB
Deceleration volume
increase correction
Purpose: Ensures engine speed stability after fuel cut recovery
Correction condition
• When recovery from fuel cut
Correction amount
• Low engine speed→large correction
B
Learning correction
Purpose: Corrects deviation in air/fuel ratio from changes due to
aged deterioration of mechanical devices
Correction condition
• Under any condition except purge control
Correction amount
• Learning value based on average of feedback correction value
BB
Intake air pressure
correction
Purpose: Corrects ineffective charging time deviation from change
in intake manifold vacuum
Correction condition
• Under any condition except start zone
Correction amount
• More intake manifold vacuum→large correction
BB
3404-1U-05F(01-40).fm 4 ページ ２００６年７月３日 月曜日 午前９時５１分