Specifications

CAUTION:
• Do not connect the ohmmeter to any circuit where voltage is applied. This will damage the
ohmmeter.
• The ohmmeter is used to measure the resistance between two points in a circuit and to inspect for
continuity and short circuits.
Precautions Before Welding
A vehicle has various electrical parts. To protect the parts from excessive current generated when
welding, be sure to perform the following procedure.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the battery cables.
3. Securely connect the welding machine ground near the welding area.
4. Cover the peripheral parts of the welding area to protect them from weld spatter.
(w) RX8-General Info
Page 42