Specifications

T140
AIR BAG SYSTEM
•
••
• The deployed air bag module and pre-tensioner seat belt may contain deposits of sodium
hydroxide, a caustic byproduct of the gas-generated combustion. If this substance gets into your
eyes or on your hands, it can cause irritation and itching. When handling the deployed air bag
module and pre-tensioner seat belt, wear gloves and safety glasses.
•
••
• Due to the adoption of 2-step deployment control in both the driver and passenger-side air bag
modules, depending on the impact force, it is possible that inflator No. 2 might not deploy. In such
cases, before disposing of the air bag module, make sure to follow the inflator deployment
procedures and verify complete deployment of inflator No. 1 and 2.
1. Put on gloves and safety glasses.
2. Put the deployed air bag module or pre-tensioner seat belt in a plastic bag, seal it, and then dispose of it.
3. Wash your hands after removing your gloves.
End Of Sie
INSPECTION OF SST (DEPLOYMENT TOOL)
A6E813001046W03
• Use the SST (Deployment tool) to deploy a live (undeployed) air bag module or pre-tensioner seat belt before
disposing of it.
• Before using the SST (Deployment tool), inspect
its operation.
Inspection Procedure
1. Follow the steps below to verify that the SST
(Deployment tool) is operating correctly.
• If not as specified, do not use the SST
(Deployment tool) because it may cause the
air bag module or pre-tensioner seat belt to
unexpectedly deploy upon connection to the
air bag module or pre-tensioner seat belt.
End Of Sie
A6E8130W043
Step Inspection procedure
Light condition
Green Red
1
Connect red clip to positive
battery terminal and black
clip to negative battery
terminal.
On Off
2
Connect connectors A and
B of SST (Deployment
tool).
Off On
3 Press activation switch. On Off
A6E8130W042