Specifications

S52
EXTERIOR ATTACHMENT
REAR DOOR GARNISH INSTALLATION
A6E772850030W02
Note
• Double-sided adhesive tape has already been attached to the new rear door garnish.
Warning
•
••
• Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
1. When installing a new rear door garnish, follow the procedure below:
(1) Remove the adhesive remaining on the body using razor.
(2) Remove any grease or dirt from the adhesion surface of the body.
2. When reusing the rear door garnish, follow the procedure below:
(1) Remove the adhesive remaining on the rear door garnish and the body using a razor.
(2) Remove any grease or dirt from the adhesion surface of the rear door garnish and the body.
(3) Apply primer to the bonding area of the rear door garnish.
(4) Attach double-sided adhesive tape to the rear
door garnish as shown.
3. Peel off the backing of the double-sided adhesive
tape, then install the rear door garnish to the
body.
End Of Sie
SIDE PROTECTOR REMOVAL
A6E772850680W01
1. Pry the side protector end 2030 mm {0.81.1 in} using a flathead screwdriver or a razor.
Warning
•
••
• Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
Note
• The side protector is installed with double-sided adhesive tape. If the side protector is difficult to remove,
soften the double-sided adhesive tape using a hot air blower.
2. Pull the side protector toward you, then remove it.
End Of Sie
A6E7728W010
A6E7728W006