Specifications

REAR OIL SEAL
B25
B
REAR OIL SEAL REPLACEMENT
A6E222211399W01
1. Remove the flywheel. (MTX) (See H11 CLUTCH UNIT REMOVAL/INSTALLATION)
2. Remove the drive plate. (ATX) (See K43 DRIVE PLATE REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
.
Rear Oil Seal Installation Note
1. Apply silicone sealant to the mating faces as
shown.
Dot diameter:
4.06.0 mm {0.160.23 in}
2. Apply clean engine oil to the new oil seal lip.
3. Install the rear oil seal using the installer as
shown.
4. Tighten the rear oil seal bolts in the order as
shown.
Tightening torque:
8.011.5 N·m {81.6117.2 kgf·m, 70.9
101.7 in·lbf}
End Of Sie
REAR OIL SEAL
1Bolt
2 Rear oil seal
(See B25 Rear Oil Seal Installation Note)
AME2222W001
AME2222W002
AME2224E326
AME2222W004