Specifications

CYLINDER HEAD GASKET, FRONT OIL SEAL
B21
B
Camshaft Installation Note
1. Set the cam position of the No.1 cylinder at the
top dead center (TDC) and install the camshaft.
2. Temporarily tighten the camshaft bearing caps in
two or three even movements.
3. Tighten the camshaft cap bolts in the order shown
using the following two steps.
(1) Tighten to 5.09.0 N·m {51.091.7 kgf·cm,
44.679.5 in·lbf}
(2) Tighten to 14.017.0 N·m {1.51.7 kgf·m,
10.412.5 ft·lbf}
End Of Sie
FRONT OIL SEAL REPLACEMENT
A6E222010602W01
1. Disconnect the negative battery cable.
2. Remove the spark plugs. (See G10 SPARK PLUG REMOVAL/INSTALLATION.)
3. Remove the Cylinder head cover. (See B17 Cylinder Head Cover Installation Note.)
4. Remove the drive belt. (See B3 DRIVE BELT REPLACEMENT.)
5. Remove the front drive shaft (RH) from the joint shaft. (See M17 DRIVE SHAFT REMOVAL/INSTALLATION.)
6. Remove the CKPsensor.(See F54 CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION.)
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
.
AME2212W009
FRONT OIL SEAL
AME2220W001
1 Crankshaft pulley lock bolt
(See B22 Crankshaft Pulley Lock Bolt Removal
Note)
(See B23 Crankshaft Pulley Lock Bolt Installation
Note)
2 Crankshaft pulley
3Front oil seal
(See B22 Front Oil Seal Removal Note)
(See B23 Front Oil Seal Installation Note)