Specifications

P54
ON-BOARD DIAGNOSTIC (ABS/TCS)
End Of Si e
DTC C1119
A6E697567650W07
5 VERIFY PUMP MOTOR OPERATION
• Turn ignition key to OFF.
• Remove SST (adapter harness) and connect
all disconnected connectors.
• Connect WDS or equivalent to DLC-2.
• Turn ignition key to ON (engine OFF).
• Access ABS_POWER and PMP_MOTOR
active command modes using WDS or
equivalent.
• Does pump motor operate?
Yes Go to next step.
No Repair ABS (ABS/TCS) HU/CM, then go to next step.
6 VERIFY TROUBLESHOOTING COMPLETED
• Clear DTC from memory.
(See P46 Clearing DTCs Procedures)
• Start engine and drive vehicle at 10 km/h
{6.2 mph} or above.
• Gradually slow down and stop vehicle.
• Is same DTC present?
Yes Replace ABS (ABS/TCS) HU/CM, then go to next step.
No Go to next step.
7 VERIFY AFTER REPAIR PROCEDURE
• Is there any other DTC present?
Yes Go to applicable DTC inspection.
STEP INSPECTION ACTION
DTC C1119 Engine control system, torque reduction inhibit signal line
DETECTION
CONDITION
• Engine RPM information through CAN is out of specification or invalid value
• Throttle information through CAN is out of specification or invalid value
POSSIBLE
CAUSE
• Malfunction of PCM