Specifications

N16
ENGINE SPEED SENSING POWER STEERING
STEERING GEAR AND LINKAGE INSPECTION
A6E661432960W03
Rack Inspection
1. Inspect the rack for cracking, damage, and tooth wear. Replace it as necessary.
2. Measure the runout of the rack.
Runout
Near point A: 0.15 mm {0.006 in} max.
Near point B: 0.20 mm {0.008 in} max.
3. If not within the specification, replace the rack.
Tie-rod End Inspection
1. Inspect the tie-rod end for damage and boot cracks. Replace it as necessary.
2. Inspect the ball joint for looseness. Replace the tie-rod end as necessary.
3. Rotate the ball joint five times.
4. Measure the rotation torque of the ball joint using
the SST and a pull scale.
Rotation torque
0.42.7 N·m {3.527.5 kgf·cm, 3.123.8
in·lbf}
Pull scale reading
3.425.5 N {0.352.60 kgf, 0.85.7 lbf}
5. If not within the specification, replace the tie-rod
end.
Tie rod Inspection
1. Inspect the tie rod for bending and damage. Replace it as necessary.
2. Inspect the ball joint for looseness. Replace the tie rod as necessary.
3. Swing the tie rod five times.
4. Measure the swinging torque using a pull scale.
Swinging torque
0.14.0 N·m {140.7 kgf·cm, 0.935.3
in·lbf}
Pull scale reading
0.624.5 N {0.062.49 kgf, 0.25.50 lbf}
5. If not within the specification, replace the tie-rod.
End Of Sie
STEERING GEAR AND LINKAGE ASSEMBLY
A6E661432960W04
Caution
•
••
• Place copper plates, rag, or similar material in a vise, when secure the mounting bracket portion of
the steering gear.
A6E0612W041
A6E6316W100
A6E0612W043