Specifications

M24
DRIVE SHAFT
6. Crimp the wheel side big boot band using the SST.
7. Verify that clearance B is within the specification.
• If clearance B is more than the specification, reduce clearance A of the SST and crimp the boot again.
• If clearance B is less than the specification, replace the boot band, increase clearance A of the SST and
crimp the new boot.
Clearance B
2.42.8 mm {0.0950.110 in}
8. Verify that the boot band does not protrude from the boot band installation area.
• If it does, replace the boot band and repeat Steps 7 and 8.
End Of Sie
DRIVE SHAFT (MTX) DISASSEMBLY/ASSEMBLY
A6E631625500W04
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
A6E6316W009