Specifications

M4
FRONT AXLE
WHEEL HUB, STEERING KNUCKLE PRE-INSPECTION
A6E631204000W01
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial
direction and measure the wheel bearing play.
Maximum wheel bearing play
0.05 mm {0.002 in}
3. If the bearing play exceeds the specification,
replace and tighten the locknut to the specified
torque and retest.
• Replace the wheel bearing as necessary.
End Of Sie
WHEEL HUB BOLT REPLACEMENT
A6E631233060W01
1. Remove the hub bolt using the SSTs.
Note
• If the dust cover interferes with the wheel
hub bolt and the wheel hub bolt cannot be
removed, tap the part shown in the figure
with a chisel lightly and bend the processing
point back to the steering knuckle side.
2. Install the hub bolt into the wheel hub and install a
washer and hub nut on the hub bolt.
3. Tighten the hub nut while holding the wheel hub
using a brass bar.
End Of Sie
FRONT AXLE
A6E0311W010
A6E0311W011
A6E0311W012