Specifications

B8
VALVE CLEARANCE
29. Hold the exhaust camshaft using a suitable
wrench on the cast hexagon as shown.
30. Tighten the exhaust camshaft sprocket lock bolt.
Tightening torque:
6975 N·m {7.107.6 kgf·m, 50.955.3 ft·lbf}
31. Remove the SST from the camshaft.
32. Remove the SST from the block lower blind plug.
33. Rotate the crankshaft clockwise two turns until
the TDC position.
• If not aligned, loosen the crankshaft pulley
lock bolt and repeat from Step 14.
34. Apply silicone sealant to the engine front cover
upper blind plug.
35. Install the engine front cover upper blind plug.
Tightening torque:
10 N·m {1.0 kgf·m, 7.4 ft·lbf}
36. Install the cylinder block lower blind plug.
Tightening torque:
1822 N·m {1.92.2 kgf·m, 13.316.2 ft·lbf}
37. Install the new engine front cover lower blind
plug.
Tightening torque:
12 N·m {1.2 kgf·m, 8.9 ft·lbf}
38. Connect the front drive shaft (RH) and the joint
shaft. (See M17 DRIVE SHAFT REMOVAL/
INSTALLATION)
39. Install the drive belt. (See B3 DRIVE BELT
REPLACEMENT.)
40. Install the cylinder head cover. (See B17
Cylinder Head Cover Installation Note.)
41. Install the ventilation hose.
42. Install the oil control valve (OCV) connector.
43. Install the high-tension lead. (See G11 HIGH-TENSION LEAD REMOVAL/INSTALLATION.)
44. Install the spark plugs. (See G10 SPARK PLUG REMOVAL/INSTALLATION.)
45. Install the splash shield (RH).
46. Install the tire (RH).
End Of Si e
AME2212W006
AME2212W003
AME2212W012
AME2212W002