Specifications

ON-BOARD DIAGNOSTIC
K59
K
Diagnostic procedure
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME PID DATA been
recorded?
Yes Go to next step.
No Record FREEZE FRAME PID DATA on repair order, then
go to next step.
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Bulletins availability.
• Is any related repair information available?
Yes Perform repair or diagnosis according to available repair
information.
• If vehicle is not repaired, go to next step.
No Go to next step.
3 INSPECT TR SWITCH CONNECTOR
• Turn ignition key OFF.
• Disconnect TR switch connector.
• Inspect for bent terminals of TR switch
terminals B and C (part-side).
• Are TR switch terminals okay?
Yes Go to next step.
No Repair terminals or replace TR switch, then go to Step 7.
(See K15 TRANSAXLE RANGE (TR) SWITCH
REMOVAL/INSTALLATION.)
4 INSPECT TR SWITCH
• Turn ignition key to OFF.
• Disconnect TR switch connector.
• Inspect for resistance between TR switch
terminals B and C (part-side).
• Is resistance okay?
(See K14 TRANSAXLE RANGE (TR) SWITCH
INSPECTION.)
Yes Go to next step.
No Adjust TR switch, then go to Step 7.
(See K18 TRANSAXLE RANGE (TR) SWITCH
ADJUSTMENT.)
DTC P0707 Transaxle range (TR) switch circuit low input