Specifications

CONTROL SYSTEM
F43
F
PCM REMOVAL/INSTALLATION
A6E394018880W01
Note
• For replace the PCM, Setup the WDS and perform the PCM configuration. (See F50 PCM
CONFIGURATION.)
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
U.K. specs.
.
CONTROL SYSTEM
A6E3940W002
1 PCM cover No. 1
(See F44 Set Nut/bolt Removal Note)
(See F44 Set Nut/bolt Installation Note)
2 PCM cover No. 2
3 PCM connector
4PCM