Specifications

FUEL SYSTEM

F33

Volume Inspection

Warning

•

••

• Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and

damage. Always carry out the following procedure with the engine stopped.

Note

• If there is an after market fuel injector tester, perform the following test.

• If there is no an after market fuel injector tester, perform Operation Test, Resistance Inspection, and

Fuel Leakage Test to verify the fuel injector is okay or not.

1. Complete the BEFORE REPAIR PROCEDURE. (See F17 BEFORE REPAIR PROCEDURE.)

2. Disconnect the negative battery cable.

3. Remove the fuel injectors. (See F28 FUEL INJECTOR REMOVAL/INSTALLATION.)

4. Connect the fuel injector to the fuel injector tester.

5. Measure the injection volume of each fuel injector using a graduated container.

• If not as specified, replace the fuel injector.

Injection volume

L3: 6171 ml {6179 cc, 2.22.7 fl oz}/15 sec.

LF: 5369 ml {5369 cc, 1.92.4 fl oz}/15 sec.

L8: 4863 ml {4863 cc, 1.72.2 fl oz}/15 sec.

6. Turn the ignition switch to LOCK position and disconnect the jumper wire.

7. Complete the AFTER REPAIR PROCEDURE. (See F17 AFTER REPAIR PROCEDURE.)

Atomization

1. Inspect atomization pattern.

• If the atomization is faulty, replace the fuel injector.

End Of Sie

A6E3912W011