Specifications

T188
ON-BOARD DIAGNOSTIC [CRUISE CONTROL SYSTEM]
DTC 13
A6E817266350W14
Diagnostic procedure
End Of Sie
DTC 15
A6E817266350W15
Diagnostic procedure
End Of Sie
DTC 13 Cruise control switch (ground circuit)
DETECTION
CONDITION
• Resistance detected between cruise actuator connector terminal J and ground is always
approximately 0 ohm.
POSSIBLE
CAUSE
• Cruise actuator malfunction
INSPECTION ACTION
INSPECT DTC FOR OPERATION MODE
• Was operation mode for DTCs 21 and 22 performed?
Yes Perform operation mode for DTCs 21 and 22 on-board
diagnostic again. Even if no malfunction is detected in
operation mode, if DTC 13 is indicated in condition detection
mode on-board diagnostic, replace cruise actuator.
(See T110 CRUISE ACTUATOR REMOVAL/
INSTALLATION)
No Perform operation mode for DTCs 21 and 22.
DTC 15 Cruise actuator (control circuit)
DETECTION
CONDITION
• Malfunction in cruise actuator circuit (control circuit)
POSSIBLE
CAUSE
• Cruise actuator malfunction
ACTION
REPLACE CRUISE ACTUATOR IF IT IS MALFUNCTIONING
• Replace cruise actuator.
(See T110 CRUISE ACTUATOR REMOVAL/INSTALLATION)