Specifications

1.3L ENG STALL/POOR IDLE - THROTTLE SENSOR ADJ CAT. 4, NO. 009/84Article Text (p. 2)

1984

Fig. 2: Checking Throttle Sensor Voltage

(b) Terminal (A) - approximately 12v & Terminal(B) - approximately

12v: Throttle sensor out of adjustment. Adjust as follows:

Turn the adjust screw counter-clockwise until the voltage at

terminal(B) becomes 0. Then turn the adjust screw an additional 1/4 to

1/2 turn counter-clockwise. Confirm that the voltages at terminals (A)

and (B) are as shown in Step 3(a).

Fig. 3: Adjusting Throttle Sensor

Terminal (B) - Ov:

Throttle sensor out of adjustment. Adjust as follows:

Turn the adjust screw clockwise until the voltage at terminal (A)

becomes approximately 12v. Then turn the adjust screw an additional

1/4 to 1/2 turn clockwise. Confirm that the voltages at terminals (A)

and (B) are as shown in Step 3(a). (Fig. 3)

4. Start the engine and run it at idle.

5. Disconnect the connector for the vent and vacuum solenoid valves.

Turn all accessories off. (Fig. 4)