Specifications

TUNE-UP - ROTARY

rticle

Remove tachometer.

Fuel Injected Models

1) Warm engine to operating temperature. Stop engine and

disconnect Green connector. Using 2 voltmeters, connect leads to Green

connector terminals. See Fig. 9. Turn ignition on and observe

voltmeters. Current should flow to 1 of the voltmeters.

Fig. 9: Voltmeters Connected to Adjust Throttle Sensor

This applies to fuel injected models.

2) If current flows to both voltmeters, remove throttle

sensor adjusting screw cap and turn adjusting screw counterclockwise.

If current does not flow to either voltmeter, turn adjusting screw

clockwise. See Fig. 10. Remove test equipment. Reconnect Green

connector and insert cap over throttle adjusting screw.

Fig. 10: Adjusting Throttle Sensor

Turn adjusting screw to adjust current flow to voltmeters.

COLD (FAST) IDLE RPM