Owner`s manual
14
4280159 Rev. A 10/10
VEHICLE’S HORN WIRE REMOTE START HARNESS WIRE
GREEN/RED GREEN/RED
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
WIRE HARNESS CONNECTIONS - BRAKE SWITCH
BRAKE SWITCH CONNECTION
1. Locate the 4-pin WHITE brake switch connector at the top of the
brake pedal. (FIGURE LL)
2. Using a razor knife carefully cut back 1”-2” of the electrical tape to
expose the wiring. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE LL &
MM for proper connector and pin location.
11
FIGURE LL
12
WIRE HARNESS CONNECTIONS - DRIVER’S KICK PANEL
FIGURE MM
VIEW FROM HARNESS SIDE
!
10
1. Using (2) supplied, short wire ties, secure the remote start harness
and immobilizer interface harness to the vehicle’s factory ignition
wire harness. (FIGURE KK)
NOTE: IT IS EXTREMELY IMPORTANT THAT THE WIRING
IS SECURED IN A MANNER THAT WILL ALLOW THE TILT
AND TELESCOPIC STEERING WHEEL TO MOVE FREELY
AND STILL ALLOW FOR REASSEMBLY OF THE STEERING
COLUMN SHROUD. CHECK FUNCTIONALITY OF THE TILT
STEERING WHEEL PRIOR TO REASSEMBLY.
FIGURE KK
WIRE HARNESS CONNECTIONS - SECURING
VEHICLE’S BRAKE WIRE REMOTE START HARNESS WIRE
GREEN/YELLOW GREEN/YELLOW
NOTE: Refer to Page 2 for IDC Wire Tap Procedure and Wire color code information.
HORN CONNECTION
1. Locate the 30-pin WHITE connector at the Body Control Module
mounted in the left kick panel area. (FIGURE NN)
2. Using a razor knife carefully cut back 1”-2” of the electrical tape to
expose the wiring. ( CAUTION: BE EXTREMELY CAREFUL
NOT TO DAMAGE ANY OF THE WIRES.)
3. Using (1) supplied IDC wire tap, connect the wires listed below
and crimp the IDC wire tap in place using pliers. Ensure that a
complete and secure connection is made. Refer to FIGURE NN
& OO for proper connector and pin location.
!
G/Y
G/R
***
3AB
3AB 3AA 3X 3U 3R 3O 3L 3I 3F 3C
3W 3T 3Q 3N 3K 3H 3E 3B
3AY
3AZ
3AC
3Z 3V 3S 3P 3J 3G
3A3D
VIEW FROM HARNESS SIDE
FIGURE OO
4-pin
30-pin
FIGURE NN