English 1 Robot Pool Cleaner by Maytronics EN User Instructions M BC8-UN I 8151830
English 2 What You’ll Find Inside the Box Part X Base frame for filter elements 2 Filters 2/4 Filters Depend on model Bag for filters storage 1 Power supply unit 1 Robot pool cleaner 1 Comment Filter and cartridges Robot pool cleaner Optional components available on request from your robot pool cleaner distributor Power supply Unit Section 1 - Description of Main Components 1. Filters Base frame + fine or ultra-fine cartridge Depend on model 2.
English 3 3. Power supply unit Digital, “Switch-Mode” power supply: • • • • • Input - 100 VAC - 250 VAC 50 Hz - 60 Hz 180 W Output - <30 VDC IP 54 ON On/Off switch Section 2 - Robot pool cleaner Operation Part 1 - Preparing the Robot Pool Cleaner for Use Laying out the cable Unwind minimal required cable to cover the entire pool size, straight the cable along the pool side. Make sure there are no twists or kinks. 3.5 m (12 ft) Swivel Only use the original supplied power supply unit.
English 4 Part 2 - Into the water Inserting the robot pool cleaner into the pool. Place the robot pool cleaner into the pool and release the handle. Note: When using the combined brushes or Wonder brushes, gently squeeze the Wonder brush material until it is totally wet. Turning the robot pool cleaner ON 1. Plug the floating cable from the robot pool cleaner into the power supply unit. 2. Plug the electrical cable from the power supply unit into the mains. 3. Press the ON/OFF switch 4.
English 5 Part 3 - Taking the robot pool cleaner out of the water Unplug power supply before any servicing activity. 1. If the robot pool cleaner has not finished its cycle, turn off the power supply unit and unplug the mains. 2. Pull the floating cable gently until the robot pool cleaner has risen to the surface, then lift by the handle. Important: Do NOT lift the robot pool cleaner from the water by its cable.
English 6 Reassembling the filter elements Locating tab Insert the locating tabs at the bottom of the filter element into their groves on the base frame, then close the “S” clip. Locating tab groove Reinstall the filters according to the diagram DO NOT FORCE THE FILTERS INTO PLACE. Grooved end fitting Octagonal end fitting Recommendation: Rinse all brushes with clean water after each cleaning cycle. Part 2 - Dismantling and cleaning the impeller Unplug power supply before any servicing activity.
English 7 Section 4 - Storage Advice Coil the cable and store in dry cool area. Do NOT store the robot pool cleaner exposed to direct sunlight. Do NOT store the robot pool cleaner exposed to excessive heat. Do NOT store the robot pool cleaner exposed to frost. Troubleshooting Guide Before contacting your robot pool cleaner distributor please read through this guide. The pool water condition must be within the following parameters: pH: 7.0 - 7.8 NaCl: 5000 ppm max.
English 8 Robot Pool Cleaner by Maytronics M BC8-UN I 8151830 www.maytronics.
