Robotic Pool Cleaner User Instructions ......................p.
EN Robotic Pool Cleaner User Instructions Contents 1. INTRODUCTION ....................................................................... 2 2. SPECIFICATIONS ...................................................................... 2 3. WARNINGS AND CAUTIONS ................................................... 2 3.1. Warnings ............................................................................ 2 3.2. Cautions ............................................................................. 2 4.
Robotic Pool Cleaner User Instructions 1. INTRODUCTION Thank you for purchasing a Maytronics Robotic Pool Cleaner. We are sure that your Maytronics Robotic Pool Cleaner will provide you with reliable, convenient and cost effective pool cleaning. Its reliable filtration in all pool conditions, active brushing, and all-surface climbing brush enhance maximum pool hygiene. Robotic Pool Cleaners by Maytronics deliver advanced cleaning technology, long lasting performance and easy maintenance.
. POOL CLEANER PARTS Robotic Pool Cleaner Classic Brushes Optional Brushes Combined Brush All surface climbing brush, ideal for most pool surfaces. PVC Brush For concrete, PVC, fiberglass and liner. Wonder Brush For smooth ceramics.
. USING THE POOL CLEANER The Pool Cleaner is very easy to use. Just follow the simple steps to get started, and your Pool Cleaner is ready to go. 5.1. Setup Before using the Pool Cleaner for the first time perform the following steps: Unwind the cable and stretch it out completely so that it has no kinks. 3m/10ft Position the power supply so that it is approximately in the middle of the long side of the pool at a distance of 3m/10ft. Some models arrive with plastic coverings on the brushes.
5.2. Putting the Pool Cleaner into the pool If your Pool Cleaner is equipped with brushes that contain sponges, dip the brushes in the water and squeeze them so that they will absorb water the first time you use the Pool Cleaner, or if the brushes have dried out between uses. Holding the Pool Cleaner upside down in the water, gently rock it back and forth with your fingers holding the plastic doors on the bottom lid open to release trapped air. Continue until no more bubbles are released.
5.3. Removing the Pool Cleaner from the pool OFF CAUTION Turn OFF and unplug the power supply. Using the floating cable, bring the Pool Cleaner to the pool’s edge. Using the handle, remove the Pool Cleaner from the pool. 10cm/4in CAUTION DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE. B A 6 C Place the Pool Cleaner on the edge of the pool and let the water drain out.
6. CLEANING THE FILTER BAG OR CARTRIDGES Depending on the model, your Pool Cleaner may be equipped with a filter bag or cartridges. It is recommended to clean the filter bag or cartridges after each cleaning cycle. 6.1. Removing and cleaning the filter bag CAUTION Unplug the power supply. Click Turn the Pool Cleaner upside-down. Open the bottom lid. Remove the filter bag. Clean the filter bag with a hose.
6.2. Replacing the filter bag Put the filter bag over the frame so that the strap is in the middle of the shortest side. Make sure that filter bag is positioned properly on the frame. 6.3. Cleaning the filter cartridges Note: Don’t let the filter cartridges dry out before cleaning. Click CAUTION Unplug the power supply. With the Pool Cleaner upside down open the bottom lid and pull it out. Open the clips and remove the filter.
Clean the filters with a hose. Insert the filters with the plastic backing facing out. Insert the cartridge unit.
6.4. Cleaning the impeller If you notice debris trapped in the impeller open the impeller and remove the debris. A CAUTION B Unplug the power supply. Using a screwdriver, remove the two screws on the impeller cover and remove it. Clear any debris that may be in the impeller. Replace the screws. 7.
8. TROUBLESHOOTING If the suggest solutions do not solve the problem contact your dealer Symptom Possible reason Corrective action 1. Cable twisting • Obstruction in pool or cable coils up • Excess cable in the pool • Filter bag/cartridge dirty • In all abovementioned cases • Remove obstruction in pool. • Remove excess cable out of the pool. • Clean filter bag/cartridge. • Straighten cable and lay in sun periodically. 2.
