Installation Instructions

7
Install In-Line Smart Kit
KVWB40DS Series Range Hoods
Remove Blower Motor from Range Hood Housing
1. Disconnect power.
2. Using two or more people, place the range hood on its back.
Be sure to set the range hood on a covered surface.
3. Using the T10 Torx
®
adapter, remove the 8 screws securing
the bottom panel to the range hood. Remove the bottom
panel and set it aside.
4. Using the T10 Torx
®
adapter, remove the 4 screws from the
blower motor cover plate. Remove the cover plate from the
motor and set it aside.
5. Disconnect the blower motor from the range hood wiring. Press
the top and bottom clip of the 9-pin electrical connector to
disconnect.
6. Using the T20
®
Torx
®
adapter with a long extension, remove
the 6 screws that secure the blower motor and insulation
retainers (2) to the range hood housing. Set the screws and
insulating retainers aside.
A. Bottom panel
B. Screws (8)
C. Range hood
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
C
B
A
A. Blower motor cover plate
B. Screws (4)
C. Range hood
A. Blower motor
B. Screws - insulation retainer (2)
C. Insulation retainers (2)
D. Screws - blower motor mounting (4)
A
C
B
A
B
C
D
D