Installation Instructions

16
Complete Installation
Determine and make all necessary cuts and drill holes for the
vent system.
IMPORTANT: When cutting or drilling into the ceiling or wall, be
sure to not damage electrical wiring or other hidden utilities.
1. Install the range hood in its final location. Use the Installation
Instructions provided with the range hood.
2. Determine the location where the ¹⁄₂" (13 mm) wiring conduit
will be routed through the ceiling or wall to connect the In-
Line Smart Kit and the range hood.
3. Drill a 1¹⁄₄" (3.2 cm) hole(s) in this location.
4. Locate the terminal box on the In-Line Smart Kit and the
terminal box on the top of the range hood.
5. Remove the cover from the range hood terminal box. Set the
cover and screws aside.
6. Remove the electrical knockout from the In-Line Smart Kit (B,
see the following illustration) and the range hood terminal
box.
7. Install the UL listed or CSA approved strain reliefs (3) in the
range hood and In-Line Smart kit electrical knockouts.
8. Connect the vent system to the vent transition on the range
hood. Connect the vent system to the vent transition located
on the bottom In-Line Smart Kit. Use clamps and metal duct
tape to seal all joints.
A. Terminal box cover
B. Screws (2)
C. Terminal box
D. Electrical knockout
A. In-line smart kit terminal box
B. Electrical knockouts
A
B
B
C
D
A
B
A. Vent transition - in-line smart kit (bottom)
B. Vent system
C. Vent transition - range hood
A
B
C