Installation Instructions

12
Connect In-Line Smart Kit
Electrical Connection In-Line Smart Kit
1. Use a UL listed or CSA approved wire connector to connect
the black wires together.
2. Use a UL listed or CSA approved wire connector to connect
the white wires together.
3. Use a UL listed or CSA approved wire connector to connect
the red wires together.
4. Use a UL listed or CSA approved wire connector to connect
the blue wires together.
5. Use a UL listed or CSA approved wire connector to connect
the gray wires together.
6. Use a UL listed or CSA approved wire connector to connect
the brown wires together.
7. Use a UL listed or CSA approved wire connector to connect
the yellow wires together.
8. Use a UL listed or CSA approved wire connector to connect
the green/yellow wires together.
9. Tighten the UL listed or CSA approved strain relief.
Electrical Connection Range Hood
10. Repeat all steps above to make the electrical connection in
the range hood terminal box.
11. Connect power supply wires together using the “Make
Electrical Connections” section in the range hood manual.
12. Reinstall the terminal box covers on the In-Line Smart Kit and
range hood.
13. Reconnect power.
Install In-Line Smart Kit
KVUB60DS Series Range Hoods
NOTE: KVUB60DS series range hoods must be top vented for
installation with the In-Line Smart Kit.
Remove Blower Motor from Range Hood Housing
1. Disconnect power.
2. Using two or more people, place the range hood on its back.
Be sure to set the range hood on a covered surface.
3. Using the T10 Torx
®
adapter, remove the 8 screws securing
the bottom panel to the range hood. Remove the bottom
panel and set it aside.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A. Bottom panel
B. Screws (8)
C. Range hood
B
C
A