Installation Instructions

6
4. Remove 2 screws from the front tabs of the flame spreader.
Lift front of the flame spreader and pull forward to remove
tabs from rear of oven and set it aside on a covered surface.
NOTE: On some models, the flame spreader will be attached
to the oven bottom, and this step will not be necessary.
5. Remove 2 screws from the bake burner.
NOTE: Some models may have a single screw holding the
bake burner in place.
6. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orifice, and set the bake burner aside.
7. Refer to the nameplate on the range located on the front
frame behind the oven door or drawer front depending on
model. Identify the bake burner rating for this range from the
nameplate. Refer to the following chart for the gas to be used
after the conversion. Identify the correct replacement bake
burner spud using the nameplate burner rating. The ID
number is marked on the hex flats of the orifice spud.
Natural Gas Orifice Spud Chart for Bake Burners
LP Gas Orifice Spud Chart for Bake Burners
8. Use a ³⁄₈" nut driver or combination wrench and turn the bake
burner orifice spud counterclockwise to remove. Save the
replaced orifice spud in a plastic bag or other container.
9. Install the replacement bake burner orifice spud, turning it
clockwise until snug.
IMPORTANT: Do not overtighten.
10. Position the back of the bake burner over the oven orifice,
and slide the tab on front of the bake burner into the front of
the oven.
11. Reattach the bake burner with 2 screws.
12. If the flame spreader is part of the oven bottom, continue with
Step 14. Otherwise, insert the tabs on the rear of the flame
spreader into the rear of the oven.
13. Reattach the front tabs of the flame spreader to the oven with
2 screws.
14. Position the front of the oven bottom panel toward the front
frame and lower the rear of the oven bottom panel into the
oven.
15. Reattach the oven bottom panel with 2 screws.
A. Screws
B. Flame spreader
A. Screws
B. Bake burner
A
B
AA
B
Nameplate Burner Ratings
(sea level)
Replacement Orifice -
Natural Gas (high altitude)
Natural Gas LP Size ID Number
18,000 BTU 17,000 BTU 1.78 mm 178
16,500 BTU 15,500 BTU 1.70 mm 170
Nameplate Burner Ratings
(sea level)
Replacement Orifice -
LP Gas (high altitude)
Natural Gas LP Size ID Number
18,000 BTU 17,000 BTU 1.09 mm 57
16,500 BTU 15,500 BTU 1.07 mm 107
A. Orifice spud
A