User Guide

Soak Only --
This program would be used to soak heavily soiled or stained items, without the washer advancing
into a wash cycle. When you touch the "Soak Only" pad, the washer will immediately begin filling,
automatically selecting large load size, cold water and 19 minutes of soak with brief periods of
agitation. "19" will appear in the display. The load size and water temperature can be changed by
touching the appropriate load and water temperature pads. The soak time can be decreased by
pressing the "LESS" pad. If the "MORE" pad is pressed, two dashes "----" will appear in the display
during fill and agitation. The washer will shut off, continuing to soak for an indefinite length of time
and will not drain. This could be used for extended soak periods. After an extended soak, you can
simply touch the "Spin" pad to spin and drain the tub.
Rinse --
This program would be used when you only want to rinse a load. When you touch the "Rinse" pad,
the washer will immediately begin filling, automatically selecting large load, cold rinse and 1 minute of
agitation. "1" will appear in the display. The load size and rinse temperature can be changed by
touching the appropriate Load pad or the "Warm Rinse" pad. The rinse agitation time can be
increased to 8 minutes by pressing the "MORE" pad.
Spin --
This program would be used any time you wish to drain the tub or spin out a load. When you touch
the "Spin" pad, the wash tub will begin spinning, automatically selecting a 5 minute spin. "5" will
appear in the display. The spin time can be increased (up to 8 minutes) or decreased by pressing the
"MORE" or "LESS" pads.
A number in the display shows the time in minutes remaining in that portion
of the cycle indicated by the four sequence lights--Soak, Wash, Rinse, Spin.
The illustration shown at the left would indicate 10 minutes of wash time.
If the
m
1111'8
following symbol appears in the display:
The washer is in "Pause". Continue the program by closing the lid and
touching "PAUSE/RESUME" pad.
The load is unbalanced. Rearrange the load, close the lid and touch the
"PAUSE/RESUME" pad.
The lid is open. Close it and touch "PAUSE/RESUME" pad.
The washer is in an extended soak program. The dashes remain in the
display for two minutes after fill is complete, then the washer shuts off.
The washer is in spin following the wash portion of the Permanent
Press program. The dash indicates this is an unspecified length of time.
IThe lid may not be properly closed. Reclose the lid, then touch the
"PAUSE/RESUME" pad to start the washer.