Specifications

ManualsBrandsMaytag ManualsOtherNeptune Washer

Troubleshooting Procedures

! WARNING

To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing

requires power.

and resume normal operations. Pressing the Off key will

completely exit Service Mode. If a cycle is running,

cancel the cycle. Pressing the Start/Pause key while

running a test will pause the individual test, while

remaining in Service Mode. A power loss during Service

Mode will cancel this mode.

Hose Reversal Detection and Correction

The washing machine has diagnostic features that

determine if the hoses are reversed on the first

complete cycle after power up. The control board

monitors water temperatures during the wash cycle.

The control system is capable of detecting hot and cold

water intake hose reversal and will change the fill

temperature as necessary after the first cycle.

The control system stores and retains hot and cold

water intake hose reversal information through a power-

down.

The system reverts to factory defaults for the cold and

hot water valves and cancels hose reversal detection if

a diagnostic code 28 has been logged in a cycle.

See “Wrong Water Temperature” in the trouble

shooting tips, at the beginning of this document for more

information.

Torque Specifications

Tub Displacement Sensor Diagnostics

CAUTION: Do not perform continuity check directly on

Displacement Sensor due to the potential for damaging

the microprocessor chip in the sensor.

1. Enter the Service Mode by pressing the

Help

and

Back

keys for three seconds.

2. Press

System Check

on the display

3. Push tub to back right corner so sensor extends

beyond the #2 mark molded on slider. Display will

show “tub unbalance”.

4. Pull tub to front left corner and push down so

sensor collapses to before the #1 mark molded on

slider. Display will show “tub unbalance”.

NOTE:

Moving the tube midway between mark #1 and

mark #2 represents normal operation. Display

will show “no unbalance”.

Spinner Support Shaft Nut 64-80 ft. lbs. Special

wrench required.

Clamp Ring 15-

20 ft. lbs.

Pulley clutch Bolt

96 in. lbs.

Tub

Displacement

Sensor

#2 Mark

#1 Mark