Operating instructions

ManualsBrandsMaytag ManualsCooktopMGR8674AB0

IN,=;TALLATI()N IN,c;TRUCTIONS

FOR AUTOMATIC WASHERS

PLEASE READAll Installation Instructions and Requirements Before Installing.

FOR YOUR SAFETY AND THE

PROPER OPERATION OF YOUR

NEW WASHER, THE WASHER

MUST BE INSTALLED IN ACCOR-

DANCE WITH ALL THE INSTAL-

LATION REQUIREMENTS.

REMOVE CARDBOARD RETAINER FROM

INSIDE WASHER. IT CONTAINS WATER

FILL HOSES, DRAIN HOSE, TIE STRAP,

LITERATURE AND PARTS BAG. SAVE

LITERATURE FOR FUTURE REFERENCE.

TOOLS REQUIRED:

_4"OPEN END WRENCH

RETAPE DOOR. PLIERS AND/OR VICE GRIPS

%8"HEX HEAD NUTDRIVER

CAUTIONS

_1_ READ OPERATIONS MANUAL BEFORE _ LOCATE WASHER IN DRY WEATHER-OPERATING WASHER. PROOF AREA THAT CAN SUPPORT

WEIGHT OF FULL WASHER.

_I_DO NOT CONNECT WASHER TO POWER

SOURCE UNTIL INSTALLATION IS _ POWER OUTLET MUST BE GROUNDED

COMPLETED. 120V AC 60 HZ. DO NOT USE AN

EXTENSION CORD.

P/N 35-4833-2 __

Summary of content (4 pages)

PAGE 1
IN,=;TALLATI()N IN,c;TRUCTIONS FOR AUTOMATIC WASHERS PLEASE READ All Installation Instructions and Requirements Before Installing. FOR YOUR SAFETY AND THE PROPER OPERATION OF YOUR NEW WASHER, THE WASHER MUST BE INSTALLED IN ACCORDANCE WITH ALL THE INSTALLATION REQUIREMENTS. REMOVE CARDBOARD RETAINER FROM INSIDE WASHER. IT CONTAINS WATER FILL HOSES, DRAIN HOSE, TIE STRAP, LITERATURE AND PARTS BAG. SAVE LITERATURE FOR FUTURE REFERENCE.
PAGE 2
INSTALLATION INSTRUCTIONS PLEASE READ ._11Installation Instructions and Requirements Before Installing. 1, REMOVESHIPPING BASE NOTE; DO NOT LOWER OR RAISETHE WASHER BYTHE BACKGUARD. a. STEP ___ INSTALL WATER FILL HOSES Position corner posts on floor as shown (step one). b. Carefully lay washer on its back on top of the corner posts. NOTE: A small amount of water may run from the pump due to factory tests. c.
PAGE 3
IN;TALLATION INSTRUCTIONS PLEASE READ All Installation 4. ADJUST LEVELING FEET Instructions b. Make sure rear feet move up and down freely, c. d. as possible. Place washer in final operating position, Tilt machine forward until rear of cabinet is approximately 4 inches off the floor, turn the machine loose letting it fall on FINAL CHECKOUT y_ • ,OCKW,S,E, w,r,,,,os rOC.ECK,_ s_e_E Proceed as follows: Position your washer as close to its final operating location Before Installing.
PAGE 4
IN,c;TALLATI()N REC!UIREMENTS PLEASE READ All Installation Instructions and Requirements Before Installing. GENERAL INFORMATION most plumbingcodes. In most cases where a tight connec- It is recommendedthat a qualified service technician install your washer, LOCATION INSTALLWASHERON A SOLID FLOOR, lion is demanded,an anti-siphon valve should be placed the drain hose to preventwater from siphoning from the in washer or facility during agitation. If required, an anti-siphon valve Part No.