Installation Instruction

8
Floor Mountinge
Wall Mountine
5. Using the Phillips screwdriver, mount anti-tip bracket to
the wall or floor with the two #12 x 1
5
⁄
8
” (4.1 cm) screws
provided.
6. Move range close enough to opening to allow for final
gas and electrical connections. Remove shipping base,
cardboard or hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
8. Move range forward onto shipping base, cardboard or
hardboard to continue installing the range using the following
installation instructions.
Make Gas Connection
Typical rigid pipe connection
A combination of pipe fittings must be used to connect the
range to the existing gas line. Your connections may be different,
according to the supply line type, size and location.
1. Apply pipe-joint compound made for use with Propane gas
to all pipe thread connections.
2. Using a pipe wrench to tighten, connect the gas supply to
the range.
Typical flexible connection
1. Apply pipe-joint compound made for use with Propane gas
to the smaller thread ends of the flexible connector adapters
(see B and G in the following illustration).
2. Attach one adapter to the gas pressure regulator and
the other adapter to the gas shutoff valve. Tighten both
adapters.
Rear position Front position Diagonal (2 options)
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to propane, have a qualified person make
sure gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
A
B
C
D
E
F
G
H
I
J
A. Gas pressure regulator
B. 90° elbow (must have ½”
(1.2 cm) male pipe thread)
C. Nipple
D. Union
E. Black iron pipe
F. Manual gas shutoff valve
G. ½” (1.2 cm) or ¾” (1.9 cm)
gas pipe
H. Nipple
I. Union
J. 90° elbow