Specifications
A – 8 16022498 ©2003 Maytag Appliances Company
Gas Conversion
7
&RQYHUWLQJ %URLO %XUQHU 2ULILFH
q ` _ _ lW
1. Remove ALL oven racks.
2. Remove one screw in front of broil burner, then gently
position broil burner assembly against rear wall of oven
cavity. This will expose the broil orifice. See figures 1
and 2.
3. Using 1/2² socket, remove broil orifice by turning
counter-clockwise till orifice is loose from brass fitting.
Seefigure2.
4. Locate LP broil burner orifice in LP conversion kit
plastic bag mounted at rear of range. Orifice will be
marked “#57” and colored green.
5. Repeat step #3 above to install broil orifice. Turn
socket clockwise until resistance is felt, then another
1/4 turn to fully tighten.
6. Reverse step #2 above to re-install broil burner to
complete the conversion.
fjmloq^kqW Be sure end of burner is engaged over
burner orifice.
klqbW Pin attached at radius of bend on burner must
be inserted in embossed hole in top rear wall of oven
cavity.
_ _ ^ p ^
Refer to section titled “Range Adjustments” in installation
manual for proper air shutter adjustment after orifice broil
is changed.
cfdrob N
cfdrob O
BROIL ORIFICE
TURN COUNTER CLOCKWISE
TO REMOVE. LP BROIL ORIFICE IS
LOCATED IN THE LP CONVERSION
KIT AND HAS #57 AND GREEN
INDICATOR MARK ON ITS SIDE.